PUMP1
Pump control unit for Wilo Geniax 1.0 pump, without bus connection
Application
The PUMP1 is a pump control unit and is used to control a Wilo Geniax 1.0 pump. The pumps are electrically controlled via the pump module, which is installed independently of the pumps but in their immediate vicinity. The pump speed and thus the mass flow and the heating capacity are specified by the control range set by means of a potentiometer.
Technical Data
| Power supply voltage: | 230V AC ±15% |
| Max. current draw: | 50 mA at max. speed |
| Pump speed: | adjustable with potentiometer: 1000 - 6000 rpm |
| Terminals: | 2-pin screw terminal up to 1,5mm² |
| Plug for pump: | RJ12 |
| Housing: | made of plastic, polyamide, Colour pure white (similar to RAL 9016) |
| Dimensions WxHxD: | 57 x 81 x 30 mm |
| Ambient temperature: | 0...+50°C |
| Installation: | Wall-mounting |
| Cable gland: | M16, with tension relief |
| Humidity: | < 95 % rH, non-condensing air |
| Protection type: | IP20 |
| Protection class: | III (according to EN 60 730) |
| Standards: | CE conformity |
| EMC: | according to EN 61326 |
